Again, I use the combination of a hammer and cleaver. Ugly, isn't she? Trim the excess ice until you have a crystal clear, rectangular block of ice.I like putting my cutting board on a towel so it does not slide around and it absorbs the excess water. Turn the hardliner upside down on to a cutting board, towel or clean sink and press on the bottom until the entire ice block slides out. Take the cooler out of the freezer and remove the plastic hardliner from the insulation.Place the entire cooler setup, again with the lid open in your freezer for 24 to 30 hours.Fill the cooler with plastic hardliner with filtered water until it is about half-full (optimism, folks).This is even more simple, you will not need anything except water, the Ozark Trail cooler and plastic hardliner start by assembling the cooler.There are a ton of ice carving videos on YouTube, I suggest watching a few of these before committing to carving your own cubes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |